How Do I Turn On My Irrigation System
How do i turn on my irrigation system. Slowly open until water comes out of. You can now inspect your system zone by zone. Turn the dial to the MANUAL position.
Turn the dial to the RUN position to run the station only the designated station will water then controller will return to automatic mode with no change in the previously set program. Knowing how to turn off the water supply to your irrigation system when leaks occur will save you a lot of money on your water bill. Turn off the controller for your irrigation system first if it has one.
If your leak only happens when the system is running then turning the sprinkler irrigation controller to the off position will stop the water flow and the leak. Your irrigation system wont know when your lawn is ready to be watered. This process is typically done with an air compressor.
A small screwdriver or a pen will do the trick. To close the valve turn the lever 90 degrees a quarter turn. Next step turn the valve in the picture below on BUT turn it on very slowly it should take about 60 seconds to turn on.
Close the drain and turn the water on. This is the fully open position. Station run time will flash in the display.
Use the button to move to the desired station. About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy Safety How YouTube works Test. Resetting a Hunter X-Core is easy.
If your irrigation system has a drip line ensure that those lines are also drained. Once its confirmed that the programming is fine if the sprinklers still dont turn on we can move toward troubleshooting the rest of the system.
A small screwdriver or a pen will do the trick.
This is always the first thing we check and you should definitely double-check it yourself before calling for help. STEP 4 Go back outside to the backflow device and turn the handle C parallel to the pipe up and down. Of course you can always have Spinniken Turn On your sprinkler system. Go to one of the irrigation valves and turn the solenoid 14 to 12 a turn counter-clockwise. Leave this valve open then remove the sprinkler nozzle to allow air to escape when you turn on the water. Set the pressure regulating valve on the compressor to 50 psi. Sometimes the levers are old and rusty or even broken off. A small screwdriver or a pen will do the trick. If your system has multiple branches feeding off a mainline you should open the valve and remove the nozzle of the last sprinkler on every branch line.
Drain all of the irrigation components that are above ground and may hold water. Leave this valve open then remove the sprinkler nozzle to allow air to escape when you turn on the water. If this is the case do not try to turn it. How Do I Winterize My Irrigation System Insulate your assets. Your irrigation system wont know when your lawn is ready to be watered. For a ball valve turn the lever handle one-quarter turn until the handle is parallel to the pipe. Sometimes the levers are old and rusty or even broken off.
Posting Komentar untuk "How Do I Turn On My Irrigation System"